151
192 F0T0936
After driving for about 8 km / 5
miles, position the vehicle in a safe
and suitable area and engage the
handbrake. Take the compressor
and restore pressure using the black
inflation tube (L) fig. 192.
If the pressure shown is higher than
1.8 bar / 26 psi, restore the pressure
and drive safely to a Fiat Dealership
as soon as possible. If, however, the
pressure is lower than 1.8 bar / 26 psi,
do not resume driving but contact a
Fiat Dealership.
PROCEDURE FOR
RESTORING THE
PRESSURE
Proceed as follows:
stop the vehicle safely, as shown
above, and operate the handbrake;
extract the black inflation tube (L)
fig. 192 and screw it firmly onto the tyre
valve. Follow the instructions shown in
fig. 190 and fig. 192.
Press the air release button (M) fig. 189
to adjust any tyre overpressure.
CARTRIDGE
REPLACEMENT
Proceed as follows:
only use original Fix&Go cartridges,
which can be purchased from the Fiat
Dealership.
to remove the cartridge (A) fig. 187
press the release button (H) fig. 191
and lift it.
WARNING
128)
The information required by the
applicable regulation is indicated on the
Fix&Go kit package label. Carefully read
the label on the cartridge before use,
avoid improper use. Fix&Go is subject
to expiration and must be replaced
periodically. The kit should be used by
adults and cannot be used by children.
129)
IMPORTANT: Do not exceed
80 km/h. Avoid sudden acceleration or
braking. The kit provides a temporary
repair, therefore the tyre must be
examined and repaired by a specialist as
soon as possible. Before using the kit,
ensure that the tyre is not excessively
damaged and that the rim is in good
condition, otherwise do not use it and
call roadside assistance. Do not remove
foreign bodies from the tyre. Do not let the
compressor turned on for more than 20
consecutive minutes - overheating hazard.
IMPORTANT
29)
The sealant fluid is effective with
external temperatures from -40°C to
+50°C. The sealant fluid has an expiry date
and must be replaced periodically. It is
possible to repair tyres with damage on
the tread up to a maximum diameter of
6 mm. Show the cartridge and the label
to the personnel who will handle the tyre
treated with the repair kit.
REPLACING A BULB
GENERAL
INSTRUCTIONS
130) 131) 132) 133) 134)
Before replacing a bulb check the
contacts for oxidation;
burnt bulbs must be replaced by
others of the same type and power;
always check the headlight beam
direction after changing a bulb;
when a light is not working, check
that the corresponding fuse is intact
before replacing a bulb. For the
location of fuses, refer to the paragraph
"Replacing fuses" in this chapter.
WARNING A slight misting may
appear on the internal surface of the
headlight: this does not indicate a fault
and is caused by low temperature
and the degree of humidity in the air.
Misting will rapidly disappear when
To Next Page
Loading...
