141
FUEL TANK CAP
170 F0T0068
Opening
1) Open the flap (A) fig. 170 by pulling it
outwards, keep the cap (B) fig. 170 still,
insert the ignition key in the lock and
turn it anticlockwise.
2) Turn the cap anticlockwise and
remove it.
The cap has a device (C) fig. 170 which
attaches it to the flap so that it cannot
be lost. When refilling, attach the plug
to the flap, as shown.
Closing
1) Fit the cap (complete with key) and
turn it clockwise until it clicks once or
more.
2) Turn the key clockwise and extract it,
then close the flap.
The sealing may cause a slight
pressure increase in the tank. A little
breathing off, while slackening the cap
is absolutely normal.
NATURAL POWER
VERSIONS
METHANE GAS FILLER
The methane filler is located near the
petrol filler fig. 171.
171 F0T0360
It has a check valve, located in the filler
body.
To access the filler, undo the cap (A)
fig. 172 turning it anticlockwise.
The profile of filler (B) fig. 172 for refilling
is the universal type compatible with
Italian and NGV1 standards.
172 F0T0346
In some European countries adapters
are considered ILLEGAL (e.g. in
Germany).
For service stations with cubic metre
(m
3
) nozzles (pressure differential) the
check valves must be released by
delivering a small amount of methane
to measure the residual pressure in the
cylinder.
The plates (provided with the vehicle
documentation) contain the date for the
first inspection of the cylinders.
26)
Fuels - identification of
vehicle compatibility.
Graphic symbol for
consumer information
in accordance with
EN16942
The symbols shown below aid
recognising the correct fuel type to
be used on your vehicle. Before
proceeding with refuelling, check the
symbols inside the fuel filler flap (where
provided) and compare them with
the symbols shown on the fuel pump
(where provided).
Symbols for petrol fuelled vehicles
To Next Page
Loading...
