31
The direction indicator on the side
selected will be activated for 3 flashes
and then go out automatically.
FOG LIGHTS
(for versions/markets, where provided)
Press button fig. 39 with the
side/tail lights on to turn the fog lights
on. Instrument panel warning light
comes on.
Press the button again to switch the
lights off.
39 F0T0501
REAR FOG LIGHTS
Press button fig. 39 with the dipped
beams or front fog lights on to turn
the rear fog lights on. Instrument panel
warning light comes on.
Press the button again to turn the
lights off or turn off the dipped beam
headlights and/or the front fog lights
(for versions/markets, where provided).
"FOLLOW ME HOME"
DEVICE
This device lights up the space in front
of the vehicle for a short time.
Activation
With the ignition key in the STOP
position or extracted, pull the lever
towards the steering wheel and move
it within 2 minutes of the engine
switching off.
Each time the stalk is moved, the lights
stay on for an extra 30 seconds up to
a maximum of 210 seconds; then the
lights are switched off automatically.
Each time the stalk is moved,
instrument panel warning light
comes on and the corresponding
message will appear on the display
(see the “Warning lights and messages”
chapter in the "Knowing the instrument
panel" section) for as long as the
function remains on. The warning
light comes on when the stalk is
operated and stays on until the function
is automatically deactivated. Each
movement of the stalk only increases
the amount of time the lights stay on.
Deactivation
Keep the stalk pulled towards the
steering wheel for more than 2
seconds.
LIGHT BEAM DIRECTION
The correct alignment of the headlights
is essential for the comfort and safety
of the driver and other road users. To
ensure the best visibility when travelling
with the headlights on, the headlight
alignment must be correct. Contact a
Fiat Dealership to have the headlights
checked and adjusted.
HEADLIGHT ALIGNMENT
CORRECTOR
This device works with the ignition key
in the MAR position and the dipped
headlights on.
The vehicle tilts backwards when it is
laden, raising the beam.
The beams must therefore be realigned
in this case.
Headlight alignment adjustment
Press or on the control panel
fig. 40.
40 F0T0502
To Next Page
Loading...
