READ THIS CAREFULLY!
REFUELLING
Petrol engines: only refuel with unleaded petrol with an octane rating (RON) of no less than 95 conforming to the European
specification EN228.
Diesel engines: only use diesel fuel for motor vehicles conforming to the European specification EN590. The use of other
products or mixtures may damage the engine beyond repair and consequently invalidate the warranty, due to the damage
caused. For further details on the use of the correct fuel see the "Refuelling the vehicle" paragraph in the "Starting and
driving" chapter.
Refuelling with methane: refuel only with methane for motor vehicles. The use of other products or mixtures may damage
the engine beyond repair and consequently invalidate the warranty, due to the damage caused. For further details on the use
of the correct fuel see the "Refuelling the car" paragraph in the "Starting and driving" chapter.
STARTING THE ENGINE
Petrol or petrol/methane engines: make sure that the handbrake is engaged; set the gear lever to neutral; fully depress
the clutch pedal without pressing the accelerator; turn the ignition key to AVV and release it as soon as the engine has
started.
Diesel motors: Make sure that the handbrake is engaged; set the gear lever to neutral; fully depress the clutch pedal
without pressing the accelerator, then turn the ignition key to MAR and wait for the warning light to switch off; turn the
ignition key to AVV and release it as soon as the engine has started.
PARKING ON FLAMMABLE MATERIAL
The catalytic converter develops high temperatures during operation. Do not park on grass, dry leaves, pine needles or other
flammable material: fire hazard.
RESPECTING THE ENVIRONMENT
The vehicle is fitted with a system that allows continuous diagnosis of the emission-related components in order to help
protect the environment.
ELECTRICAL ACCESSORIES
If, after buying the vehicle, you decide to add electrical accessories (with the risk of gradually draining the battery), visit a
Fiat Dealership. They can calculate the overall electrical requirement and check that the electrical system of the vehicle can
support the required load.
To Next Page
Loading...
