KNOWING YOUR VEHICLE
40
perform the following preventive
window demisting procedure:
bring cursor to (B) to ;
turn the knob (A) to ;
turn the knob (C) to 2;
turn the knob (D) to with the
option of moving to position if there
is no sign of the windows misting up.
ADJUSTING THE FAN
SPEED
To ventilate the passenger
compartment properly, proceed as
follows:
fully open the central and side air
vents
turn knob (A) to the blue section;
bring cursor to (B) to ;
turn knob (C) to the required speed.
turn the knob (D) to .
INTERNAL AIR
RECIRCULATION
ACTIVATION
Bring cursor (B) to .
It is advisable to switch the internal
air recirculation on while standing in
queues or in tunnels to prevent the
introduction of polluted air.
Do not use the function for a long
time, particularly if there are several
passengers on board, to prevent the
windows from steaming up.
WARNING Internal air recirculation
makes it possible to reach the required
heating or cooling conditions more
quickly depending on the selected
operating mode. Do not use the
internal air recirculation function on
rainy/cold days to avoid the possibility
of the windows misting.
CLIMATE CONTROL
SYSTEM (cooling)
Proceed as follows:
turn knob (A) to the blue section;
turn the knob (C) to 4 ;
bring cursor to (B) to ;
turn the knob (D) to ;
press knob (C).
Adjusting cooling
Proceed as follows:
bring cursor to (B) to ;
turn knob (A) to the right to increase
the temperature;
turn knob (C) to the left to reduce the
fan speed.
HEATED REAR
WINDOW AND DOOR
MIRRORS DEMISTING /
DEFROSTING
(for versions/markets, where provided)
53 F0T0048
Press button fig. 53 to activate the
function. The LED on the button comes
on to indicate activation.
Press again to disable the function
in advance.
WARNING Do not apply stickers on
the inside of the rear window over the
heating filaments to avoid damage.
ADDITIONAL HEATER
(for versions/markets, where provided)
This device warms up the passenger
compartment more quickly when it
is very cold and the engine coolant
temperature is low.
The additional heater comes on
automatically when the engine is
started, if knob (A) is turned to the last
red sector and the fan (knob (C)) is at
least at the first speed level.
To Next Page
Loading...
