KNOWING THE INSTRUMENT PANEL
74
confirmed by pressing the SET
button briefly) will be saved.
From the standard screen, press
the SET button briefly to start
browsing.
Press or to browse within the
menu.
Not. Only the short menu may be
accessed for reasons of safety while
the vehicle is moving ("Speed Buzzer"
setting). Stop the vehicle to access the
full menu.
Adjusting the vehicle interior
lighting
This function is available with the
dipped beam headlights on to adjust
brightness of the instrument panel,
buttons and radio display.
Proceed as follows to adjust the light
intensity:
press the SET button briefly to
make the display flash the previously
set level;
press button or to set the
required brightness level;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Speed limit (Speed Beep)
This function is used to set a vehicle
speed limit (km/h or mph); the driver
is alerted when this limit is exceeded
(see “Warning lights and messages”
in the "Knowing the instrument panel"
chapter).
To set the desired speed limit, proceed
as follows:
briefly press the SET button: the
display will show the wording (Speed
Beep);
press button or to
select speed limit activation (On) or
deactivation (Off);
if the function is On, press or
to select the required speed limit
and then press SET button to
confirm.
Note The speed may be set anywhere
between 30 and 200 km/h or 20 and
125 mph, depending on the previously
chosen unit, see the “Setting the unit
of measurement (Units)” paragraph.
The setting will increase/decrease
by 5 units each time button
/ is pressed. Hold down the
/ button to automatically
increase/decrease the setting rapidly.
Complete the adjustment with single
presses of the button when you
approach the desired value.
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
To cancel the setting, proceed as
follows:
briefly press the SET button
briefly to make the display flash (On);
press : (Off) will flash on the
display;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Trip B On/Off (Trip B data)
This function can be used to activate
(On) or deactivate (Off) the Trip
B display (partial trip). For more
information see the "Trip computer"
paragraph.
Proceed as follows to switch the
function on/off:
press the button press the button
SET button briefly to make the
display flash On or Off depending on
the previous setting;
press or to make your
choice;
press the SET button briefly
to return to the menu screen or hold
the button down to go back to the
standard screen without saving.
Setting the clock (Set time)
This function allows the adjustment of
the clock through two submenus: Time
and Format.
To carry out the adjustment, proceed
as follows:
To Next Page
Loading...
