Fibocom L850-GL - 4.4 Receiver Sensitivity

Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
L850-GL Hardware User Manual Page 46 of 54
Mode Band 3GPP Requirement(dBm) Tx Power(dBm) Note
Band 66
23±2.7
23±1 10MHz Bandwidth, 1 RB
LTE TDD
Band 38
23±2.7
23±1 10MHz Bandwidth, 1 RB
Band 39
23±2.7
23±1 10MHz Bandwidth, 1 RB
Band 40
23±2.7
23±1 10MHz Bandwidth, 1 RB
Band 41
23±2.7
23±1 10MHz Bandwidth, 1 RB
4.4 Receiver Sensitivity
The receiver sensitivity for each band of the L850 module as shown in the following table:
Mode Band 3GPP Requirement (dBm)
Rx Sensitivity(dBm)
T
y
pical
Note
WCDMA
Band 1 -106.7 -110 BER<0.1%
Band 2 -104.7 -110 BER<0.1%
Band 4 -106.7 -110 BER<0.1%
Band 5 -104.7 -111 BER<0.1%
Band 8 -103.7 -110 BER<0.1%
LTE FDD
Band 1 -96.3 -101.5 10MHz Bandwidth
Band 2 -94.3 -101.5 10MHz Bandwidth
Band 3 -93.3 -102 10MHz Bandwidth
Band 4 -96.3 -102 10MHz Bandwidth
Band 5 -94.3 -103 10MHz Bandwidth
Band 7 -94.3 -101 10MHz Bandwidth
Band 8 -93.3 -102.5 10MHz Bandwidth
Band 11 -96.3 -99 10MHz Bandwidth
Band 12 -93.3 -102.5 10MHz Bandwidth
Band 13 -93.3 -102.5 10MHz Bandwidth
Band 17 -93.3 -102.5 10MHz Bandwidth
Band 18 -96.3 -103 10MHz Bandwidth
Band 19 -96.3 -103 10MHz Bandwidth