Fidelity Electronics 19eA - Auto Power Off, Display Brightness; When Powered by External Power Adaptor; When Instrument Is Powered by Rechargeable Battery; Customer & Product Code

22
6.9. Auto Power Off, Display Brightness
6.9.1 When powered by external power adaptor
Both auto power off function and auto power saving function will be automatically disabled.
6.9.2 When instrument is powered by rechargeable battery
When F31 is set to on, LED indications and light bars brightness will turn to minimum when weight remains
stable / unchanged for 30 second.
6.10 Customer & Product Code
This instrument supports product and customer code entry. Both Product and Customer code accept numeric
numbers, letters, symbols and any combination of these. Maximum code length = 18 digits. Refer to below table
for code entry assignment.
Key
Assignment
0
0
Space
1
1
-
/
_
2
2
A
B
C
3
3
D
E
F
4
4
G
H
I
5
5
J
K
L
6
6
M
N
O
7
7
P
Q
R
S
8
8
T
U
V
9
9
W
X
Y
Z
Check
Shift
Note: - When inputting upper case letters, OK Light Bar will appear.
6.10.1 Enter a customer & product code manually
28
1. Go to customer/product code setting manual by either one of the below method.
• If Quick Manual Code Entry function (PCd) in F11 is set to on: -
◼ Press [Func] until C.P. Code appears then press [Print/M+].
◼ Press [Func] or [Unit] until the desired mode appears (select C Code to enter customer
code or select P Code to enter product code), then press [Print/M+] to confirm.
• If Quick Manual Code Entry function (PCd) in F11 is set to Off: -
◼ Go to F19, then press [Print/M+].
◼ Press [Func] or [Unit] until the desired mode appears (C Code for customer code, P Code
for product code), then press [Print/M+] to confirm.
2. Instrument displays H code followed by the 1st 6 digits. Enter the first 6 digits of the code here,
then press [Print/M+] to confirm.
3. Instrument displays M code followed by the 2nd 6 digits. Enter the 7th ~ 12th digits of the code
here, then press [Print/M+] to confirm.
4. Instrument displays L code followed by the 3rd 6 digits. Enter the last 6 digits of the code here, then
press [Print/M+] to confirm.
5. Instrument displays PLu=?. At this point: -
28
If a customer/product code is less than 18 digits, press [Print/M+] to skip all blank digits displayed until instrument return to F19.