25
2. Enter preset tare value through numeric keys then press and hold [Tare] for 2 seconds.
3. Instrument displays Save =?. At this point: -
• Press the preferred PLU position (numeric key 0 ~ 9), then press [Print/M+] to save to that PLU
position, or
• Press [Print/M+] to utilize this preset tare immediately but without saving to PLU, or
• Press [Zero] to quit.
6.11.3.2 Recall preset tare from PLU
Follow the below steps to recall preset tare value.
1. Select desired operation mode and weight unit, then press and hold [Tare] for 2 seconds.
2. Instrument displays PT =?. Press PLU position (numeric key 0 ~ 9) then press [Print/M+] to recall the
preset tare value stored in that position.
3. Preset tare value stored is now effective.
6.11.3.3 Clear preset tare from PLU
Refer to 6.11.3.1. Enter zero value in step number 2. Then press the preferred PLU position to clear.
6.11.4 Customer / product code PLUs
6.11.4.1 Save customer/product code to PLU
Refer to 6.10.1 for procedures to save a customer/product code to PLU.
6.11.4.2 Recall a customer / product code from PLU
Follow the below steps to recall a customer/product code from PLU.
1. Select desired operation mode and weight unit, then press and hold the PLU position (numeric key 0
~ 9) then press [Print/M+] to recall the product or customer code stored in that position.
2. Press [Func] or [Unit] until the desired mode appears (select C Code for customer code or select P
Code for product code), then press [Print/M+] to confirm.
3. Code stored is now effective.
6.11.4.3 Clear customer / product code from PLU
Refer to 6.10.1 and enter blank value for all H, M and L codes in step numbers 2, 3 and 4. Then press the
preferred PLU position to clear.
To Next Page
Loading...