5.5 Setting Comport 1 & Comport 2
5.6 Optical Key
An optical key is located on the display panel. Refer to the marking for exact location of this key. The vertical
detection distance is about 2.5cm.
According to F32 setting, this optical key can be disabled or assigned to simulate as one of the [Zero], [Tare]
or [Print/M+]. To disable optical key, select Off in F32.
6. Basic Operations
6.1 Power On, Inputting Operator Number & Power Off
To power on press and hold [On/Off] for 0.5 second.
To power off press and hold [On/Off].
After powered on, instrument will display: -
a. Software number.
b. Software revision.
c. All display segments.
d. Calibration count value.
e. Parameter set count value.
f. Battery voltage.
g. Capacity & division set (in the format of Max plus 1 division).
h. At this point, depends on internal function number F28 setting, instrument may ask for operator number
input. If this is the case: -
• Input 4-digit operator number, or
• Press [CE/x10] then [Print/M+] to skip operator number when oP appears.
i. At this point, instrument is in weighing mode and is ready for operation.
6.2 Warm Up Time & set Weight to Zero when Unloaded
It is important to allow the instrument enough warm up time. This is especially important when this instrument
is running at high resolution (e.g. 6000d or higher) application. Refer to 1.3 for details.
If zero result is not obtained when unloaded, press [Zero] to set weight displayed to zero.
6.3 Keyboard Lock
When keyboard lock is enabled, only [On/Off], [Zero], [Tare] and [Set] key can function. Refer to F20 on 5.4
for keyboard lock settings.
6.4 Tare Modes
Tare function is used to cancel the weight of a box or a container in order to get the net weight result. Various
tare modes are available. Refer to below paragraphs for details.
To Next Page
Loading...