Fidelity Electronics 19eA - Page 17

F21
Lab 2 Weight Function Output Print
Format
** STD
CUSTOM
F22
Lab 2 Counting Function Output Print
Format
** STD
CUSTOM
F23
Reserved.
F24
Lab 2 Animal Functions Output Print
Format
** STD
CUSTOM
F25
Reserved.
F26
Near Zero
Weight Value
** 000000
Near Zero value is useful for dynamic weight check applications to bypass unnecessary LO alarm during uploading and unloading process. Notes: -
 Value entered valid only when Check function is activated.
 Near zero weight value can be any value between 20d and LO limit.
 Any near zero value which less than 20d will be ignored. Instrument will deem 20d as minimum near zero weight value.
 The HI LO comparison remains non-activated when weight reading is less than the near zero value entered here.
F27
Reserved.
F28
Ask for Operator Number when Power on
Yes
** No
 Yes: - Instrument will ask for operator number during countdown process when power on. Enter 4-digit operator number or press [CE/x10] to skip operator number when being
asked.
 No: - Instrument will not ask for operation number.
F29
Read Calibration and parameter set counts.
 O (Parameter set count): - shows total times that the important parameters (F80~F88) has been altered.
 C (Calibration count): - shows total times of calibration.
F30
Allow Letters and Symbols for Customer
& Product Code Manual Entry
On
** Off
F31
Auto Power Saving
Off
** On
 Off = Auto Power Saving disable.
 On = Display brightness will switch to minimum when weight remains unchanged for 30 seconds.
Note: - Auto Power Saving will be disabled when an energized power adaptor is plugged in.
F32
Optical Key Assignment
 ** Off (Key disable)
 [Zero]
 [Tare]
 [Print / M+]