TWINFLEX
®
pro² Control Panel Engineering and Commissioning Manual
25
Access Level 1 (Normal): Controls Enabled LED off
At Access Level 1 (Normal), the main Fire Alarm Controls are disabled and the following System
Controls will only be accessible if a fire, fault or disablement is active on the panel:
These are described below. Note that actual display indications may differ from those shown in the grey
boxes below, depending on actual set up.
The Active Log will display any current fires. These are displayed in
text format and may be scrolled through by pressing the UP and
DOWN keys. Press the ESC key to exit the menu.
.
The Active Log will display any current faults. These are displayed in
text format and may be scrolled through by pressing the UP and
DOWN keys. Press the ESC key to exit the menu
The Active Log will display any current disables. These are displayed
in text format and may be scrolled through by pressing the UP and
DOWN keys. Press the ESC key to exit the menu.
Note: When in the normal mode, the quiescent screen will automatically change to display any fires or faults
on the system.
To Next Page
Loading...
