FT-70/75 Fill Level Inspectors Operator’s Guide
4-4
24 High Resolution Encoder Minimum Distance Error
25 High Resolution Encoder Minimum Time Error
* 27 High Resolution Encoder Failure
28 Consecutive Missing Label (front/back)Alarm.
* 33 Smashed Bottle Detection Error-Exceeded Consecutive Reject Limit
* 34 Smashed Bottle Detection Error-False Trigger
* 46 Consecutive External Reject Alarm
47 Encoder Resolution Too Low
* 48 AC Input Voltage Low, Brownout Detected
* 49 User Defaults Closed For One Or More Settings
50 System Defaults Loaded For One Or More Settings
51 Container Passed With No Encoder Pulses
52 Container Less Than 10 Ms
53 Reject Watchdog Detected Queue Error
54 Reject Queue Count
58 Abnormally Large Container Detected
61 Reject Delay Position Error
64 Label look distance is too short.
66 Fill Level Reject Detection is Turned Off During Inspection
67 Diameter Missing Cap Error-Exceeded Consecutive Reject Limit
68 Diameter Missing Cap Error-No Encoder Pulse
72 Production Line Speed Too High
86 BBU RAM Battery is Low
87 Broken Slat Or Pin
88 Broken Slat Sensor Failure
89 Slat Sensor Is Off
90 Broken Slat Sensor Adjustment Error
* 91 Broken Slat Pushplate
92 Too many containers in dud queue.
93 Possible sliding container, missing lid, bulged end, or improper dud sensor position.
94 Container diameter is smaller than Dud reference diameter.
95 Dud reference readings are too dissimilar.
96 Calculated dud inspection window is too small.
97 Difference between good and bad dud is less than 10.
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...