Chapter 4: Diagnostics and Troubleshooting
4-5
98 The number of dud containers in the series alarm was exceeded.
99 The number of dud containers in the series alarm was exceeded.
100 Dud signal was too short for dud reference diameter.
108 Dud sensor signal late or container edge not found.
109 Dud sensor signal early or container edge not found.
111 Dud inspection window length exceeded.
112 Dud reference diameter calibrated larger than inspection window.
113 Possible sliding container or bulged end. Missed leading reference.
114 Possible sliding container or bulged end. Missed trailing reference.
116 Dud reference point less than 3/4 calibrated reference diameter.
117 Modbus Serial Interface Framing Error
118 Modbus Serial RX Overrun Error
119 Modbus Serial Parity Error
120 Modbus Serial RX Receive Rate Error
121 Modbus CTS Line Rate Error
123 X-ray Status Turned Off
124 X-ray Source Disabled
125 X-ray Source Malfunction Detected
126 X-ray Source Warming Up For 3 Minutes
* Activates alarm only when the Beacon Status function is set for High Priority Only.
Industrial Dynamics Company, Ltd. Document 40274-0600
To Next Page
Loading...