EN
102
7.5.6 SERVICE TOOLS menu
In the SERVICE TOOLS section it’s possible to access the following sub-menus:
FIRMWARE UPDATE
CONNECTIVITY CHECK
COUNTRY STANDARD
DATE/TIME
RESET MANUFACTURING (Only visible with Admin Plus privileges)
FIRMWARE UPDATE
By accessing to the Firmware Update sub-menu you can upgrade the firmware of the inverter and his components selecting the Remote
firmware Update or the Local firmware Update.
NOTE – D This inverter can be powered both with AC or DC sources. In case of DC source only is used, Perform the update during
good irradiation conditions (avoid the dawn and dusk hours).
NOTE – D An interruption of updating process could damage the inverter!
• Remote firmware Update:
In remote mode, the firmware will update automatically, searching the last available firmware on Fimer servers, by clicking the
“CHECK” button.
1. At the end of the verification process the available release will be notified on the bottom part of the section.
2. Click on “UPDATE” button to start with the updating process.
• Overnight update mode:
By selecting this mode, the firmware will be automatically updated during the night. In this way it’s possible to avoid energy harvesting
interuption due to update process.
• Local firmware Update:
By updating in local mode, the firmware have to be selected and uploaded from local folder of the devices used to access to the Web
User Interface.
The latest firmware version is available from the download area of the website www.fimer.com or from https://registration.solar.fimer.
com
1. Click on “FW SELECT” and select the firmware package previously downloaded.
•
2. Click on “UPDATE” button to start with the updating process.
To Next Page
Loading...
