– 10 –
Quick Arm Feature
“Quick Arm” may be programmed , allowing use of the [#] key in place of the
security code for arming (Quick Arm will not work unless the Master code has
been programmed into the system).
Optional Output Relays
• Up to 4 relays using one Ademco 4204 Relay Module
• Up to 2 relays using one Ademco 4229 Zone Expansion/Relay Module
• Actions programmable to respond to zone activity or manual keypad entries
Optional Phone Module
• Supports the FA4285 Phone Module which can provide access to the
system via on premises or off-premises phones for arming, disarming, etc.,
plus control of relay outputs.
Optional Long Range Radio
• Allows all messages that have been programmed to go to the primary
telephone number to be reported additionally to an Ademco 7720 PLUS or
7820 radio.
Alarm Output
• Provides a 12VDC, 2 AMP output that can drive the compatible sounders
listed in the EXTERNAL SOUNDERS section (assumes a fully charged
battery is connected).
• Steady output for Burglary/Panic, or temporal pulse sounding output for Fire
notification, as required by UL.
• Uses current limiting circuitry for protection.
Auxiliary Power Output
• Provides 12VDC, 500mA max. Uses current limiting circuitry for protection.
• This output interrupts for smoke detector reset if 4-wire smoke detectors are
used on basic wired zone 5 (if zone 5 is programmed for fire).
Programming
• Programmed options are stored in electrically erasable, non-volatile
EEROM memory (information can be reprogrammed at any time and will
not be lost in the event of a power loss).
• The system can be uploaded, downloaded, or controlled via an IBM
compatible computer, First Alert’s FADL downloading software (or
Compass
Windows downloading software), and a HAYES modem specified by First
Alert (see the separate Programming Guide).
Keypad programming consists of:
• Data field programming
• Interactive (menu) mode programming
For programming from a keypad, an FA550KP 2-line Alpha keypad must be
connected (but need not necessarily stay in the system).
Communication Formats Supported
• 4+2 Ademco Low Speed (Standard).
• 4+2 Radionics (Standard).
• 4+2 Ademco Express.
• Ademco Contact ID.
Zone Descriptors
You can assign Alpha descriptors to all zones (useful only when using Alpha
keypads and/or the FA4285 Phone Module).
AC Power Supply
Uses No.1321 120VAC plug-in transformer with 16.5VAC 25VA output.
Back-Up Battery
• Rechargeable (Gel type) 12VDC, 4AH minimum.
To Next Page
Loading...
Need help?
General
