EasyManua.ls Logo

Fischer Panda 8000i - Starter Battery Verification and Electrolyte Checks

Fischer Panda 8000i
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Instructions
Seite/Page 116 - Kaptitel/Chapter 7: Maintenance Instructions 16.1.15
Wipe off all oil splashes from the generator and make sure that the drain screw has no leak.
7.7.1 After the oil change
Put the oil dipstick back into the check rail.
Close the oil filling cap.
Remove potential oil stains and splashes from the generator and surroundings.
Close the generator casing.
Remove lock against accidental generator start.
Duly dispose of used oil and filter.
Used oil is very toxic and must not be disposed with domestic waste. It is prohibited to dispose used oil with
waste water! Make sure that used oil is disposed properly (e.g.: where oil is bought or at collection stations).
7.8 Verifying the starter battery and (if necessary) the battery bank
Check the condition of the battery. Proceed here as prescribed by the battery manufacturer.
If from the battery manufacturer not otherwise mentioned.
7.8.1 Battery
7.8.1.1 Check battery and cable connections
Fig. 7.8.1.1-1: Battery Keep battery clean and dry.
Remove dirty clamps.
Clean terminal posts (+ and -) and clamps of the battery,
and grease with acid-free and acid-resistant grease.
When reassembling, ensure that clamps make good
contact. Tighten clamp bolts hand-tight.

Table of Contents

Related product manuals