Fischer Panda 8000i - Replacing the Valve Cover Gasket at Kubota 02 Series

Maintenance Instructions
Seite/Page 140 - Kaptitel/Chapter 7: Maintenance Instructions 16.1.15
7.17 Replacing the valve cover gasket at Kubota 02 series
NOTE:Representative procedureThe described procedure is representative for Fischer Panda
generators. The original location of the item must be taken
from the generator description of this manual. All
replacements and repairs should be done by a trained
person.
Fig. 7.17-1: De-aerating hose1. Remove de-aerating hose. Use Cobra pliers to open the
Cobra clamp.
2. Clean during reinstallation.
3. Remove the cap nuts of the valve cover (3). Wrench with
W.A.F. of 10 mm.
4. Remove the valve cover (1).
5. Replace the valve cover gasket (2) with new gasket.
6. Insert the valve cover (1) taking care not to damage the
O-ring.
7. Tighten the cylinder head screws (3) after filling with
engine oil. Torque: 3.9 to 5.9 Nm.
Fig. 7.17-2: Valve cover
10
1. Valve cover
2. Valve cover gasket
3. Hex nut