Installation Instructions
16.1.15 Kapitel/Chapter 5: Installation Instructions - Seite/Page 73
5.7.2 Installation PMGi inverter - See separate PMGi 8000 inverter manual
5.8 Installation of the cooling system
5.8.1 The cooling system / general instructions
The Fischer Panda vehicle generator is delivered without a radiator, with the exception of generators with perma-
nently installed radiators such as the PVK-UK or the PSC series.
Depending on the purpose and installation situation, a wide variety of Fischer Panda radiators are available for the
optimum customization of the system. Operation with a commercially available vehicle radiator is possible. The cor-
responding dimensioning must be implemented by the installer.
Note:For generators with a permanently installed radiator (e.g.
PVK-UK series), the radiator dimensioning and the
installation are not necessary.
5.8.2 Optionally available components for the installation of the cooling system
For the installation of the cooling system, additional components will be required, these can be procured individually
or as an installation kit from Fischer Panda.
Fig. 5.8.2-1: Coolant hosesCoolant hoses
For use in outdoor areas, check the technical data (e.g. UV
resistance).
Example
Fig. 5.8.2-2: Pipe elbowsPipe elbows
With hose connector or thread
Example
To Next Page
Loading...
