Fischer Panda Panda 6000i PMS - Indirect Cooling of the Genset Housing (by the Heat Exchanger)

Installation Instructions
Page 36 Panda_6000i_System_eng_s01835.book.R01 - Chapter C: Installation Instructions 16.1.09
C.3.6 Indirect cooling of the genset housing (by the heat exchanger)
Fig. C.3.6-1: Installation scheme indirect cooling of the genset housing
1. Ventilation valve
2. Exhaust elbow
3. Raw water pump (Raw water impeller pump)
4. Heat exchanger
5. Raw water filter
6. Water cock
7. Hull inlet