Panda PMGi 6000
Page 96 - Chapter A: Panda PMGi 6000 PGMi 6000_eng.fm
Fischer Panda Datasheet
A.1 Safety instruction
The generator may not be taken into use with the cover removed.
The rotating parts (belt-pulley, belts, etc) must be covered and protected so that there is no danger to life and
body!
If a sound insulation cover must be produced at the place of installation, then well-placed signs must show that
the generator can only be switched on with a closed capsule.
All servicing-, maintenance or repair work may only be carried out, when the motor is not running.
Electrical power: DANGER TO LIVE!
Electrical voltages above 48 volts (battery chargers greater than 36 volts) are always dangerous
to life). The rules of the respective regional authority must be adhered to. Only an electrician
may carry out installation of the electrical connections for safety reasons.
Before start working at the Panda i-series Generator (service, repair ect), diconnect the starter
battery (First minus cable, then positive cable). This avoid unexpected start of the generator.
A.2 Type plate
1. Location of the type plate
Fig. A.2-1: Type plate
To Next Page