Flashforge DREAMER - Generating Rilievo and Model Shapes; Generating Rilievo

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
32
Method 4: Click [File]--[Examples] to load the example files
Method 5: Click [File]--[Recent Files] to load the files opened recently.
Method 6: Select and drag the target file to the icon of FlashPrint.
Note: 3D models can be stored as .STL, .OBJ , .3MF and .FPP file and support edit
by FlashPrint.
Generating Rilievo
Load a .png, .jpg, .jpeg or .bmp picture file into the FlashPrint. And the following
dialogue box(6-4) will pop up. The setting box includes settings for shape, mode,
maximum thickness, base thickness, bottom thickness, width, height, top diameter and
bottom diameter.
Shape: including plane, tube, canister and lamp.
Mode: including “darker is higher” and “lighter is higher”.
Maximum thickness: Z value of the model
Base thickness: The minimum raft thickness and the default value is 0.5mm
Width: X value of the model
Depth: Y value of the model
Bottom thickness: For tube, canister, lamp and seal to set up bottom thickness
Top diameter : For tube, canister, lamp and seal to set up the top diameter
Bottom diameter : For tube, canister, lamp and seal to set up the bottom diameter
6-4