Flashforge DREAMER - Temperature Control and Firmware Update; • Temperature Control; ② Update Firmware

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
52
● Temper ature Control: Input the temperature you want to get in the left frame,
click [Apply], the printer will automatically heat the corresponding part, the right side
shows the current actual temperature of corresponding part. After start heating, the
below curve of temperature form will start to change, different color correspond with
different parts’ temperatures
② Update Fir mware
Every time when you start FlashPrint, it will automatically detect and download the
up-to-date firmware. If any update is available, a dialog box will pop up for reminding
the users to update.
Step 1: Click [Tools]--[Update fir mware]. It needs to cut off connection before
updating firmware. If software and printer are already in connection, it will remind
you cutting off the connection. Then choose [Yes] and go on to the next step.
Step 2: Choose corresponding printer type and firmware version and click [OK] in
the firmware updating box. After confirming the printer is in free state, the software
will automatically update the firmware.
6-24
Step 3：Reboot you Dreamer and wait for 4-5 seconds, then you can see the update
process bar. When the update finishes, it will go back to the main interface.
Step 4：Tap [Tools]--[About] to check whether the updated version is right.