Flashforge DREAMER - Page 62

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
63
password, save the information and restart to take effect. Your PC connect the
network, which was registed.
7-3
7. Open FlashPrint, click[Print]--[Connect Machine]. Under “Connection Mode”,
select Wi-Fi, and enter the “IP Address” as shown on Dreamer touch screen. Then,
click [Connect].
8. Now the Dreamer is connected with FlashPrint. A status box at the lower right
corner will show the temperature of both extruders and the Platform.
9. In FlashPrint, click [Pr int]. A printing options screen will appear. Make sure that
“PLA” is selected under “Material Left.” Advanced settings can be set by clicking
on [Mor e Options]. Check the box of “Pr int When Slice Done”, and click [OK].
10. Save the file at any location, and the object will start slicing. After the object is
done slicing, it will automatically upload the gcode to the Dreamer. After the gcode is
done uploading, the printer will go into a preheat phase. The Dreamer will start
printing once preheating is finished.
NOTE: Pr inting from SD car d is unavailable when WiFi is ON.
Printing with Suppor t
If the 3D model has excessive over-hang, then support will be needed. In the Slice
options screen, select from “Supports” the left or right extruder. Click [OK] to begin
slicing.