Flashforge Corporation
Dreamer User Guide | www.flashforge.com
① Do not touch the nozzle and build plate during printing.
② Do not touch the nozzle after finishing printing.
③ Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing
and gloves away from moving parts.
④ Do not operate the device while you are tired or under the influence of drugs,
① Do not leave the device unattended for long.
② Do not make any modifications to the device.
③ To lower the build plate before loading/unloading filament. (The distance between
the nozzle and build plate should be kept for at least 50mm)
④ Operate the device in a well-ventilated environment.
⑤ Never use the device for illegal activities.
⑥ Never use the device to make any food storage vessels.
⑦ Never use the device to make any electrical appliance.
⑧ Never put the model into your mouth.
⑨ Do not remove the models with force.
· Environment Requirements
The device must be placed in a dry and ventilated environment. The distances of the
To Next Page
Loading...
