Flashforge DREAMER - Filament and Legal Information; Filament Requirements; Filament Storage; Legal Notice

Flashforge Corporation
Dreamer User Guide | www.flashforge.com
9
left, right and back side space should be at least 20cm, and the distance of the front
side space should be at least 35cm.
· Filament Requir ements
Do not abuse the filament. Please make sure you use the FlashForge filament or the
filament from the brands recommened by FlashForge.
· Filament Stor age
All polymers will be degraded with time. Do not unpack until filament is needed.
Filament should be stored in clean and dry conditions.
Legal Notice
All the information in this document is subject to any amendment or change without
the official authorization from FlashForge.
FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND
WITH REGARD TO THIS DOCUMENT, INCLUDING, BUT NOT LIMITED TO,
THE IMPLIED WARRATIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
FlashForge shall not be liable for errors contained herein for incidental consequential
damages in connection with furnishing, performance or use of this material
This document contains proprietary information protected by copyright.
Copyright © 2017 FlashForge Corp. All Rights Reserved