Flashforge Inventor - Page 48

Inventor User Guide | www.flashforge.com 0086‐ 0579‐82273989
48
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, which means you haven’t installed the driver in the software.
6-19
Method 2
：
Connect Via WIFI
1. Turn on Inventor. Make sure the build plate is leveled and filament is loaded on the
left extruder.
2. Turn on Wi-Fi on the Inventor. To do this, press [Tools], [ Setting ], [WIFI],and
[WIFION].
3.
A
connection called“HF-LPB” can
b
e foun
d
on the list of available networks.
Connect to this network.
4. Open your Internet browser. Type in “10.10.100.254” and hit [ Enter ] on your
keyboard. Enter the username and password to login. The default username and
password are both “admin.” The control panel will appear after a successful login.
6‐20