Flexim FLUXUS G601 - Special Funct. Branch Navigation; System Settings Navigation Tree

A Menu Structure FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 175
selection of the physical quantity to be moni-
tored
This display will only be indicated for R1 if
Alarm Output is activated.
input of the upper limit of the physical quantity
to be monitored
This display will only be indicated if Alarm
Output has been activated and MAX has been
selected as the switching condition.
input of the lower limit of the physical quantity to
be monitored
This display will only be indicated if Alarm
Output has been activated and MIN has been
selected as the switching condition.
input of the limit for the totalizer of the physical
quantity to be monitored
This display will only be indicated if Alarm
Output has been activated and QUANT. has
been selected as the switching condition.
input of the hysteresis for the lower or upper
limit
This display will only be indicated if Alarm
Output has been activated and MIN or MAX
has been selected as the switching condition.
Program Branch Special Funct.
main menu: selection of the program branch
Special Funct.
SYSTEM settings
selection of Special Funct.\SYSTEM set-
tings
cold start
resistant
R1 Input: ↕
act. Volume flow
High Limit:
-10.00 m3/h
Low Limit:
-10.00 m3/h
Quantity Limit:
1.00 m3
R1 Hysterese:
1.00 m3/h
par mea opt >SF<
Special Funct.
Special Funct. ↕
SYSTEM settings