Camera web interface
10
To take a snapshot, follow this procedure:
1. On the toolbar and in the View modes section, click Snapshot.
2. The Notification text Snapshot stored is temporarily displayed under the live image.
10.4.14 Pausing the live image stream
To pause or freeze the live image stream, follow this procedure:
1. On the toolbar and in the View modes section, click Freeze.
2. To resume the live image stream, click Unfreeze.
10.4.15 Hiding the overlay graphics
To hide all overlay graphics in the live image, follow this procedure:
1. On the toolbar and in the View modes section, click Hide overlay.
2. To show any hidden overlay graphics, click Show overlay.
10.4.16 Camera presets
It is possible to save the current camera setup, including measurement tool configura-
tions, alarms, and colorization settings. The zipped file with the presets is saved to disk
in your Downloads folder. It can later on be uploaded and applied.
10.4.16.1 Saving a preset
To save the current camera setup, follow this procedure:
1. In the Active measurements section, click Save preset.
10.4.16.2 Loading a preset
To load a saved preset file, follow this procedure:
1. In the Active measurements section, click Load preset. The standard Windows Open
dialog box appears.
2. Browse to the Downloads folder (or to the folder where you have stored the preset
files).
3. Select the file, and then click Open. This loads and applies the presets.
10.5 Administration tab
Note The Administration tab is only available for the admin role.
Under the Administration tab you can for example, manage firewall and network settings
and see system and firmware details.
10.5.1 Firewall
Use the settings on the Firewall page to configure how the functions and services of the
camera are allowed to be accessed.
Note The services also need to be enabled which is done on the Services page.
10.5.2 SSL certificates
A network client program that is setup to communicate with or control the camera re-
motely must be approved first, which is done on the SSL certificates page. The client up-
loads a certificate which is then shown in the Certificates list, and then the camera
administrator can approve the client. Approved clients can be revoked later on.
Temporarily enable the Auto approve functionality while setting up the network clients.
However, it is recommended to disable Auto approve when all setup is completed.
10.5.3 Services
Use the Services page to enable and disable the services of the camera.
#T810409; r. AH/78915/78915; en-US
31