12 Pairing Bluetooth devices
General
Before you can use a Bluetooth device with the camera, you need to pair the devices.
Procedure
Follow this procedure:
Go to (Settings).
1
Go to the Connectivity tab.2
Activate Bluetooth.
Note: You also need to activate Bluetooth connectivity on the external de-
vice.
3
Select Add Bluetooth device.4
Select Scan for Bluetooth device, and wait until a list of available devices
is displayed. This will take about 15 seconds.
5
When a Bluetooth device is found, select the device to add it. The device
is now ready to be used.
6
NOTE
■
You can add several devices.
■
You can remove an added device by selecting the device and and then selecting
Remove.
■
After adding a MeterLink device, such as the Extech MO297 or EX845, the result
from the meter will be visible in the measurement result table.
■
After adding a Bluetooth-enabled headset, it is ready to be used in camera preview
mode.
■
It is also possible to add live snapshot values in preview mode.
24 Publ. No. T559597 Rev. a554 – ENGLISH (EN) – September 27, 2011
To Next Page
Loading...
Need help?
General
