FLIR E95 User Manual

Cleaning the camera
25
CAUTION
• Be careful when you clean the infrared lens. The lens has a delicate anti-reflective coating.
• Do not clean the infrared lens too vigorously. This can damage the anti-reflective coating.
25.3 Infrared detector
25.3.1 General
Even small amounts of dust on the infrared detector can result in major blemishes in the
image. To remove any dust from the detector, follow the procedure below.
Note
• This section only applies to cameras where removing the lens exposes the infrared
detector.
• In some cases the dust cannot be removed by following this procedure: the infrared de-
tector must be cleaned mechanically. This mechanical cleaning must be carried out by
an authorized service partner.
CAUTION
In Step 2 below, do not use pressurized air from pneumatic air circuits in a workshop, etc., as this air usu-
ally contains oil mist to lubricate pneumatic tools.
25.3.2 Procedure
Follow this procedure:
1. Remove the lens from the camera.
2. Use pressurized air from a compressed air canister to blow off the dust.
#T810190; r. AI/41890/41890; en-US
104

FLIR E95 Specifications

General

Brand	FLIR
Model	E95
Category	Thermal cameras
Language	English