Handling the camera10
5. To check the status of the battery charging, do one of the following:
• If the camera is turned on: Place your finger at the top of the screen and swipe
down. The battery status is displayed on the swipe-down menu.
• If the camera is turned off: The battery charging indicator is displayed on the screen.
6. It is good practice to disconnect the USB battery charger from the mains socket when
the battery is fully charged.
10.1.3 Using the stand-alone battery charger to charge the battery
10.1.3.1 Stand-alone battery charger LED indicator
Type of signal Explanation
The white LED flashes. The battery is being charged.
The white LED glows continuously. The battery is fully charged.
10.1.3.2 Procedure
Follow this procedure:
1. Put one or two batteries in the battery charger.
2. Connect the power supply cable plug to the connector on the battery charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. When the white LED on the battery charger glows continuously, the batteries are fully
charged.
5. It is good practice to disconnect the stand-alone battery charger from the mains socket
when the batteries are fully charged.
10.1.4 Charging the battery using a USB cable connected to a computer
Follow this procedure:
1. Fold up the rubber cover at the top of the camera.
#T810190; r. AI/41890/41890; en-US
27
To Next Page
Loading...
Need help?
General
