EasyManua.ls Logo

FLIR MR265 - Page 24

FLIR MR265
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Interface Menus
5
Figure 5.23 Settings menu items
• IGM™ Custom mode: Select the readings that you wish to display when
the IGM™ Custom Mode is enabled in the Measurement Menu, Section
5.5.
Figure 5.24 IGM™ Custom mode selections. Pick the items to display in the IGM™ Cus-
tom mode
• Measurement Parameters: Use the Measurement Parameters menu to
set the Temperature Units, Emissivity factor, and IR Temperature & Mois-
ture Alarms. These are explained below:
• Temperature units selection: Select ℃ or ℉.
Figure 5.25 Selecting temperature units of measure
• Emissivity selection: Select an emissivity preset or choose a custom set-
ting. See screen examples below:
#NAS100070; r. AB/77165/77326; en-GB
18

Table of Contents