User Interface Menus
5
Figure 5.26 Selecting the Emissivity
• IR Temperature & Moisture Alarms: Set the IR Temperature Alarm to
ABOVE, BELOW, or OFF. When an IR Temperature alarm is set to ABOVE
or BELOW, the MR265 will alert you when the IR Temperature exceeds the
high limit (temperature display turns red) or falls below the low limit (tem-
perature display turns blue). When an IR Temperature alarm is set to OFF,
the alarm is disabled.
Set the Moisture Alarm to ABOVE or OFF. When a Moisture alarm is set to
ABOVE, the MR265 will alert you when the moisture measurement ex-
ceeds the high limit (moisture reading turns red and beeper sounds, if en-
abled). When a Moisture alarm is set to OFF, the alarm is disabled. The
Moisture alarm utility also allows you to select BEEP or NO SOUND for the
alarm alert. See Section 7.9 High Moisture Alarm and Section 8.4 High/
Low IR Temperature Alarms for more information.
Figure 5.27 Setting IR Temperature and Moisture Alarms
#NAS100070; r. AB/77165/77326; en-GB
19
To Next Page
Loading...
