FLOWBIRD STRADA PAL - Page 95

STRADA PAL – MAINTENANCE MANUAL
95/149
8.4.3 Replacing the battery of the Datapack / Neopsdata board
8.4.3.1 Preliminary operations
A. Open the maintenance door
B. Turn off the terminal
C. Disassemble the Neopsdata board
8.4.3.2 Replacement
A. Slide the battery of the Neopsdata out of its location.
Replacing the battery of the Datapack board
8.4.3.3 Installation
A. Repeat the previous steps in reverse.
8.4.3.4 End of procedure
A. Check that the fault " WARN_DATAPACK_BATTERY_LOW" no longer appears.
B. Turn on the terminal
C. Close the maintenance door