FLOWBIRD STRADA PAL - Page 98

STRADA PAL – MAINTENANCE MANUAL
98/149
8.4.6 Updating the software
8.4.6.1 Preliminary operations
A. Open the maintenance door
B. Turn off the terminal
8.4.6.2 Update
A. Connect the loader (1) equipped with a programmed MMC (2) to the main board
equipped with a Neopsdata version V2.1.
B. Turn on the main board using the ON/OFF switch.
C. The terminal then connects to the loader.
Neops loader and MMC
If no update is needed, a message is displayed.
If an update is required, the loading starts automatically.
Ignore flashing LEDs during loading.
D. Turn off the terminal
E. Disconnect the loader from the main board.
8.4.6.3 End of procedure
A. Turn on the terminal
B. Close the maintenance door