Chapter 4: Maintenance
Periodic Maintenance
Hyperion Imaging System User Guide
53
2 Loosely screw on the new Injector Sealer Cap (with the O-ring) to the Injector Holder.
3 Carefully insert the injector into the Injector holder. Pull the Injector in and out to confirm
that there is sufficient tension on the Injector but that you are still able to insert and
remove it.
WARNING Finger cut hazard. Broken glass may cause injury or cutting of
fingers or hands.
4 Ensure that the cap is finger tight. Do not overtighten.
5 Remove the Injector and place it aside.
To Next Page
Loading...
