1730
Users Manual
34
Reset to Factory Defaults
The reset function deletes all user data, such as logging
sessions and screen captures, and sets the instrument
settings to default values. It also enables the first-time use
wizard the next time the instrument boots.
To reset:
1. Push .
2. Push (Instrument Settings).
3. Push (Tools).
4. Push to highlight or touch Reset to Factory
Defaults target.
5. Push to continue. A display message will prompt
you to continue or cancel the reset.
First-time Use/Setup Wizard
To start the Logger:
1. Attach the power supply to the Logger or use the DC
power cord to connect the Power Supply with the
Logger.
2. Connect the power cord into the power supply.
The Logger starts up in <20 seconds and the Setup
Wizard starts.
3. Pick the language (see page 30).
4. Push (Next) or to navigate to the next page.
5. Push (Cancel) to close the setup wizard. If you
cancel, the setup wizard starts again on next startup of
the logger.
6. Pick the work standards for your region. This action
selects the color codes and the phase descriptor (A, B,
C or L1, L2, L3).
This is the best time to apply the correlating decal on
the connector panel. The decal helps you to quickly
identify the appropriate voltage test lead and current
probe for the different phases and neutral.
7. Attach the color clips to the current probe cables.
8. Pick your time zone and date format. Confirm that the
correct date and time are shown on-screen.
9. Pick the currency sign or currency code.
To Next Page
Loading...
Need help?
General
