Energy Logger
Maintenance
37
Maintenance
If the Logger is used appropriately it does not require
special maintenance or repair. Maintenance work may be
executed only by trained and qualified personnel. This
work may only be done at a company related service
center within the guarantee period. See www.fluke.com for
locations and contact information of Fluke Service Centers
worldwide.
Warning
To prevent possible electrical shock, fire, or
personal injury:
• Do not operate the Product with covers
removed or the case open. Hazardous
voltage exposure is possible.
• Remove the input signals before you clean
the Product.
• Use only specified replacement parts.
• Have an approved technician repair the
Product.
How to Clean
Caution
To avoid damage, do not use abrasives or
solvents on this instrument.
If the Logger is dirty, wipe it off carefully with a damp cloth
(without cleaning agents). Mild soap may be used.
Battery Replacement
The Logger has an internal rechargeable Lithium-ion
battery.
To replace the battery:
1. Remove the Power Supply.
2. Unscrew the four screws and remove the battery door.
3. Replace the battery.
4. Fasten the battery door.
Caution
To prevent damage to the Product, use only
original Fluke batteries.
Calibration
As an additional service we offer the regular examination
and calibration of your Logger. The recommended
calibration cycle is 2 years.
More information about how to contact Fluke is on page 2.
To Next Page
Loading...
Need help?
General
