Fluke 1735 - Standard and Optional Accessories

Power Logger
Standard and Optional Accessories
3
• Maintenance work must be done only by qualified
service personnel.
• Use only specified current probes. If you use
flexible current probes, wear suitable protective
gloves or work on de-energized conductors.
• Protect the Logger against wetness and humidity.
• To prevent electrical shock, always connect
voltage and current test leads to the Logger before
connecting to the load.
• The plug and socket connection for the voltage
lead set is designed for 600 V CAT III. The
maximum voltage between outer conductor and
earth potential must not exceed 600 V. With multi-
phase connections, phase-phase voltage may not
exceed 800 V.
• Use only the provided original or specified
accessories. This includes the ac power adapter.
Adequate qualifications are the following:
• Trained and authorized to switch on/off, ground (earth) and mark
power distribution circuits and devices in accordance with the safety
standards of electrical engineering.
• Training or instruction in accordance with the standards of the safety
engineering in maintenance and use of appropriate safety equipment.
• Training in first aid.
Standard and Optional Accessories
The standard equipment for the Power Logger is listed in Table 2. Optional
accessories are listed in Table 3.