Fluke 732B - Safety Summary

Safety Summary
Safety Terms in this Manual
Instrument models described in this manual (Models 732B and 734A) have been designed
and tested in accordance with IEC Publication 348, Safety Requirements for Electronic
Measuring Apparatus. This Instruction Manual contains information, warnings, and cautions
that must be followed to ensure safe operation and to maintain the instrument in a safe
condition. Use of these instruments in a manner mot specified herein may impair the
protection by the instrument.
Warning statements identify conditions or practices that could result in personal injury or
loss of life.
Caution statements identify conditions or practices that could result in damage to the
equipment.
Symbols Marked on Equipment
Power Off Switch Position
Power On Switch Position
Ground (Earth) Terminal
Attention — refer to the manual. This symbol indicates that
information about the use of a feature is contained in the manual.
Power Source
The instruments are intended to operate from a power source that will not apply more
than 264V ac rms between the supply conductors or between either supply conductor and
ground. A protective ground connection by way of the grounding conductor in the power
cord is essential for safe operation.
Use the Proper Fuse
To avoid fire hazard, use only a fuse identical in type, voltage rating, and current rating
as specified on the rear panel fuse rating label. Never bypass a fuse by shorting across
the fuse terminals.
Grounding the Standard
These are Safety Class I (grounded enclosure) instruments as defined in IEC 348. To
avoid electrical shock, plug the power cord into a properly wired earth grounded
receptacle, or ground the GROUND binding post before connecting anything to any of
the instrument binding posts. A protective ground connection by way of the grounding
conductor in the power cord is essential for safe operation when using ac line power.
Use the Proper Power Cord
Use only the power cord and connector appropriate for the voltage and plug
configuration in your country.
Use only a power cord that is in good condition.
Refer cord and connector changes to qualified service personnel.
www.valuetronics.com