Documenting Process Calibrator
Setting Up the Calibrator
27
4. Press
e or the
Choices softkey. The
display appears as follows:
gj40s.eps
5. The ID string is shown at the bottom of the boxed
area. To erase a character, press the
Back
Space
softkey. To erase the whole string, press
c.
6. Press u, d, L, or R to select a character, then
press e. Use the numeric keypad if you
want to enter a number.
7. Repeat step 6 until you are satisfied with the ID
string appearing in the window.
8. Press the
Done softkey.
9. Press the
Done softkey or s to exit Setup
mode.
To Next Page
Loading...
