Fluke 93 - Power Adaptor; Power Supply

CHARACTERISTICS
2-17
2.17
2.18
CHARACTERISTICS SPECIFICATIONS
ADDITIONAL INFORMATION
•
DAC Output Current
Can
be used for a component
Amplitude
0 mA...+ 3mA
tester.
In max. 126
amplitude st^. The
Max. voltage
2V
time
for
every step can differ.
*
DAC output voltage
In max. 126 amplihjde
steps. The
Amplitude
-2V...+
2V
time for every step
can
differ.
Max. Current
± 1 mA
POWER ADAPTOR /BATTERY CHARGER
*
Input Connector
5 mm Power Jack
Per DIN 45323
*
Source Voltage
dc
Nominal 15V dc
Limits
of Operation 8V...20V dc
•
Charging Current
Instrument ON
60 mA
Instrument OFF
170 mA
•
Allowable Temperature
During Charging
0®C...46 “C
•
Power Consumption
Instrument ON 5W
Instrument
OFF 3W
POWER
SUPPLY
•
Battery
Voltage Range 4V...6V
The batteries are not charged
at
delivery. A warning is given if the
battery voltage becomes lower than
4.4V, "Hie instrument is switched off
if the
battery voltage becomes
lower
than 4 V.
If the instrument Is Battery
Powered,
it will switch off
automatrcaJly after 10 minutes of
no
operator
actions, except in
RECORD
or ROLL mode.