Fluke VT650 - Performing Measurements; How to Make a Measurement; Saving Measurement Data

VT650/VT900
Users Manual
22
Measurements
Figure 8 is an example of the measurement
screen.
Make a Measurement
To make a measurement:
1. Select the type of measurement.
2. To set the offset to zero, tap Zero. Make
sure to remove all the connections.
Note
You may need to block the airflow channel
if room air currents are present.
3. To switch between Auto and manual scaling,
tap Autoscale.
Save a Measurement
The Analyzer can save readings or start a
recording to save.
To save a measurement:
1. On the measurement screen, tap Save.
2. Select the type of reading you want to save.
 Data—The current data points.
 Graph—The current data points in a
graphical format.
 Record—Set up the parameters and
start a new recording to save.