Flying Voice FTA5102 - Basic Function; Calling Phone or Extension Numbers; Direct IP Calls; Call Hold

Chapter 3 Basic Settings FTA5102/FTA5101 User Manual
24
Basic Function
Calling phone or extension numbers
To make a phone or extension number call:

Both ATA and the other VoIP device (i.e., another ATA or other SIP products) must have public IP
addresses, or

Both ATA and the other VoIP device (i.e., another ATA or other SIP products) are on the same LAN using
private or public IP addresses, or
 Both ATA and the other VoIP device (i.e., another ATA or other SIP products) can be connected through a
router using a public or private IP addresses.
To make a call, first pick up the analog phone or turn on the speakerphone on the analog phone, input the IP
address directly, end with #.
Direct IP calls
Direct IP calling allows two phones, that is, an ATA with an analog phone and another VoIP Device, to talk to
each other without a SIP proxy. VoIP calls can be made between two phones if:
 Both ATA and the other VoIP device (i.e., another ATA or other SIP products) have public IP addresses, or
 Both ATA and the other VoIP device (i.e., another ATA or other SIP products) are on the same LAN using
private or public IP addresses, or

Both ATA and the other VoIP device (i.e., another ATA or other SIP products) can be connected through a
router using public or private IP addresses.
To make a direct IP call, first pick up the analog phone or turn on the speakerphone on the analog phone,
Input the IP address directly, with the end “#”.
Call Hold
While in conversation, pressing the “*77” to put the remote end on hold, then you will hear the dial tone
and the remote party will hear hold tone at the same time.
Pressing the “*77” again to release the previously hold state and resume the bi-directional media.
Procedure
To view the SIP account status of device, open the Status web page and view the value of registration
statu s.