Chapter 4 Web Interface FTA5102/FTA5101 User Manual
Enter the IP address of the router on the local area network. All the IP
addresses of the computers which are in the router’s LAN must be in the
same network segment with this address, and the default gateway of the
computers must be this IP address. (The default is 192.168.11.1).
Enter the subnet mask to determine the size of the network (default is
255.255.255.0/24).
Enable/Disable Local DHCP Server.
Enter a valid IP address as a starting IP address of the DHCP server, and if the
router’s LAN IP address is 192.168.11.1, starting IP address can be
192.168.11.2 or greater, but should be less than the ending IP address.
Enter a valid IP address as an end IP address of the DHCP server.
Select DNS mode, options are Auto and Manual:
When DNS mode is Auto, the device under LAN port will automatically obtains
the preferred DNS and alternate DNS.
When DNS mode is Manual, the user should manually configure the preferred
DNS and alternate DNS.
Enter the preferred DNS address.
Enter the secondary DNS address.
This option defines how long the address will be assigned to the computer
within the network. In that period, the server does not assign the IP address to
the other computer.
Enable or disable; If enabled, the device will forward the DNS request of LAN-
side network to the WAN side network.
To Next Page
Loading...