Website
9
Channel Assigned Control Function(Normal mode) Function (2-in-1 mode)
CH1 Steering Wheel
Steering, to control the left/right steering.
Turn the steering wheel in clockwise or counterclockwise to
control the left/right steering and light signals.
Same as Normal mode
CH2 Thottle Trigger
Thottle, to make the model car forward and backward.
Push or pull the throttle trigger to control the model car forward
or backward, as well as light signals.
Same as Normal mode
CH3 Switch CH3
Switch the model car speed level.
Toggle the control to switch.
Same as Normal mode
CH4 Switch CH4
Switch the model car speed level.
Toggle the control to switch.
Switch the ESC battery
type
CH5 Switch CH5
Enable/disable the winch function, or switch the model car
speed level.
Toggle the control to enable/disable the winch function, or
switch the speed.
Set the operate mode of
ESC
CH6 CH6 Button
Switch the model car speed level.
Toggle the control to switch.
Control light signals
CH7 CH7 Button
Four-wheel steering switching channel
It is used to set the wheels that control the model car steering,
i.e., front wheel steering, front and rear wheels reversal steering,
front and rear wheels in the same steering, and rear wheel
steering. You can press the control to switch. It is suitable
for partial crawler types with steering on both front and rear
wheels. Switch one state per press of the control. By default, it
is front wheel steering.
Note: When switching, the buzzer's states are indicated by
the number of beeps with Tone 1: front wheel steering (beep
once), front and rear wheels reversal steering (beep twice),
front and rear wheels in the same steering (beep 3 times), and
rear wheel steering (beep 4 times).
Switch the drag brake
strength of ESC
5.System Functions
This section focuses on the functions and how to use them.
The transmitter outputs a total of 7 channels, the function assignment and settings are as follows.
5.1 Channel Description
Note: For details function in 2-in-1 mode, refer to 5.7 2-in-1 mode.
Note: Allowed to switch cyclically.
To switch among CH1 and CH3 to CH7. Follow the step below:
• In case of power-on, press the BIND button twice quickly within 1S. The number of ashes of D1 LED indicates the
switch to a specic channel. See 4.2 The LED Status of the Transmitter.
5.2 Channel Switching
To Next Page
Loading...
Need help?
General
