FlySky FS-MG7 - Firmware Update; Receiver Failsafe Modes

Website
15
6.4 Firmware Update
6.5 Failsafe
This receiver supports two failsafe modes: ON and OFF. You can set it at transmitter side. Please refer to Failsafe in
the previous description.
The 󽗉rmware of this receiver is updated through the FlyskyAssistant (Only version 3.0 or later is supported. The
󽗉rmware of FlyskyAssistant is available on the Flysky o󽗋cial website).
This receiver can be updated via the following two ways:
1. After the binding between the transmitter and the receiver (the LED of the receiver is solid on), connect the
transmitter to the computer, then open the FlyskyAssistant on the computer to update the 󽗉rmware.
2. Connect the transmitter to the computer. Then put the receiver to enter the forced update mode by referring to
the followingway (The LED of the receiver works in three-󽗊ash-one-o󽗈 mode repeatedly). Afterwards, open the
FlyskyAssistant on thecomputer to update the 󽗉rmware.
• Power on the receiver 󽗉rst, then press and hold the BIND button for more than ten seconds, when the LED of
the receiver works in three-󽗊ash-one-o󽗈 mode repeatedly, then release the BIND button.