FS-MG7
Automatic Frequency Hopping Digital System
Website
12
The transmitter will go into idle alarm state when there is no operation over 10 minutes.
• When the transimitter is in idle alarm state, the D1 LED will be in red gradual light state, and the buzzer will sound
twice quickly in cycle with Tone 1 and Tone 2 for prompt. Operations of any control on the transmitter will cancel
the alarm, as a result of the exit of the idle alarm state.
To reset the function data of the model using currently to default value.
• Press and hold the BIND and CH7 buttons of the transmitter, and power it on, to reset the data. When the setting is
successful, the buzzer will sound once for seconds with Tone 2.
Note: These will not be reset, such as the failsafe setting, binding information, 2-in-1 mode and one-way/two-way
data.
5.11 Idle Alarm
5.10 Reset Data
It is used for the safety of the model and the operator when the receiver cannot receive signals from the transmitter
normally (out-of-control).
By default, it is not set. In this case, the receiver channel has no output.
• In the normal power-on state, set the control corresponding to the channel to be congured with failsafe to the
preset position. Then, press and hold the Bind button for 3S to set the channel value of the current output to the
failsafe value. When the setting is successful, the buzzer will sound once for seconds with Tone 1.
5.9 Failsafe
Notes:
1. If the transmitter binds with a 2-in-1 ESC receiver, the receiver will automatically enter the brake mode after out-
of-control.
2. Restore to the default setting in case of re-binding.
Notes:
1. After switching to the beginner mode, the throttle D/R is a half of normal mode.
2. The setting will be save when the transmitter turns o.
is successful, The D1 LED works in two-ash-one-o mode in green for 3S cyclically and the buzzer will sound once
shortly with Tone 2.
In case of power-on, you can judge the mode of the transmitter according to the D1 LED status and buzzer sound: If
the D1 LED works in two-ash-one-o mode in green for 3S cyclically and the buzzer sounds once shortly with Tone 2,
it is the beginner mode; if the D1 LED quickly ashes green, orange and red for 2S, it is the normal mode.
To Next Page
Loading...
Need help?
General
