22. Take a male cable mount and secure it in place
on the right upper panel using two M3x12mm
screws and two M3 Nylocks.
23. Snap one end of the other section (about 19
links, note using more than 19 links will cause
the cables to be to short) of cable chain onto
the male cable mount. Secure the other end of
the cable chain onto the female cable mount.
24. Take FT6 and secure an endstop using two
M3x12mm screws and two M3 Nylocks. Insert a
M5x10mm screw and finish it off using a M5 T-
nut.
To Next Page
Loading...